Valken 2-4 Cell Lipo/LiHV Quick Balancing Smart Charger (USA)
The Valken 2-4 Cell LiPo/LiHV Quick Balancing Charger is a plug and play balancing smart charger for lithium airsoft battery packs. The LiPo charger comes with its own power supply cable, and charges LiPo battery packs at 2A through 3-pin, 4-pin, or 5-pin charging ports. This lithium airsoft charger will safely charge lithium polymer airsoft batteries incredibly fast. Balance ports support the 7.4v, 11.1v, and 14.8v, which smart balances each individual cell to ensure maximum life. The LiPo charger also features reverse polarity and short circuit protection built in, as well as over-charge and over-current protection.
Valken 2-4 Cell Lipo/LiHV Quick Balancing Smart Charger Safety Manual
Watch the 3 safety videos below if you are unfamiliar or new to charging airsoft batteries for safe and proper care, maintenance, and use of all type of airsoft battery packs and chargers.
Connect the DC power or AC adapter to the proper Lipo charger.
Always charge your new battery fully before its first use.
Plug the charger's power into an appropriate wall outlet.
To change battery charging modes between LiPo, LiFe, and LiHV press START/STOP button quickly and the red LED light will change from the LiPo mode to the LiFe mode to the LiHV mode.
Connect the battery pack to the charger with the small XH charging connector and make sure the polarity is connected in the right way.
Press and hold START/STOP button for 1-2 seconds or until the selected LED changes to green and begins to flash. Your battery is now charging.
Place battery inside a Lithium Battery Safety Bag while charging.
Battery pack is at full charge when green LED stops flashing.
Disconnect battery pack from charger before unplugging the charger from the wall outlet.
Terminate charging immediately when any malfunction is observed.